1 # Config for Ethernet card.
4 # Name of the device. Must match filename suffix.
7 # IP addresses/address prefix
9 # 24 - resembles netmask 255.255.255.0
10 # 16 - resembles netmask 255.255.0.0
12 # IPADDR may be either IPv4 or IPv6
13 # you may have up to 256 addresses set up
14 #IPADDR=192.168.0.1/24
15 #IPADDR1=192.168.0.2/24
16 #IPADDR2=192.168.0.3/24
17 #IPADDR3=192.168.0.4/24
19 # you may select which of the above addresses
20 # is primary for this interface (it'd be IPADDR1 in the example below)
23 # activate on boot? yes|no
24 # you must set it to 'yes' if you want to have this up after bootup
30 # pass parameters to dhcp client
36 # configure a 6to4 tunnel?
39 # ethtool options like WoL