# Config for Ethernet card.
#

# Name of the device. Must match filename suffix.
DEVICE=eth0

# IP addresses/address prefix
# where prefix:
# 24 - resembles netmask 255.255.255.0
# 16 - resembles netmask 255.255.0.0
# etc.
# IPADDR may be either IPv4 or IPv6
# you may have up to 256 addresses set up
#IPADDR=192.168.0.1/24
#IPADDR1=192.168.0.2/24
#IPADDR2=192.168.0.3/24
#IPADDR3=192.168.0.4/24

# you may select which of the above addresses
# is primary for this interface (it'd be IPADDR1 in the example below)
#IP4_PRIM_IF="1"

# activate on boot? yes|no
# you must set it to 'yes' if you want to have this up after bootup
ONBOOT=yes

# dhcp|pump|none
BOOTPROTO=dhcp

# pass parameters to dhcp client
#DHCP_OPTIONS="-R"

# sane qdisc
QDISC=sfq

# configure a 6to4 tunnel?
#ENABLE_6TO4=yes

# ethtool options like WoL
#ETHTOOL_OPTS="wol g"